TREATMENT INSTRUCTIONS
Car/Light Truck Engine Treatment
Download PDF
Engine Treatment Ratios
***NOTE: Read through the entire instruction sheet before installing any Microlon Products.
To Install the Microlon Products-
-
Change your oil and oil filter.
- Shake the Microlon containers for at least one minute.
- Start the engine and bring it to operating temperature. Tum the engine off and add the Engine Treatment to the crankcase, but do not exceed 20% of the total oil volume at any one time. It may be necessary to add the remaining product after the cleaners have done their job and left the engine.
- Change the fuel filter if possible. Add the Microlon Fuel Treatment to a 1/2 tank of fuel. The fuel treatment may be added later if needed.
-
Immediately operate the engine for at least one hour or 100 miles. Driving is recommended, but idling is acceptable.
- Add the Compound 90. Drain out an amount of oil equal to the amount of Compound 90 to be added to the crankcase. Drive another 100 miles or 1 hour.
***NOTE: Do not change your oil for at least 1,000 miles after treatment to make sure that you get the full benefits of a Microlon Engine Treatment.
***NOTE: Microlon is compatible with all oils & fuels including synthetics.
